Eizo RADIFORCE RX211 - Manual (Page 37)

6. Attaching an Arm

. Attaching an Arm
The LCD monitor can be used with an arm by removing the tilt stand and attaching the
arm stand to the LCD monitor.
NOTE
• If you will use the arm or stand of other manufacturers, confirm the followings to the
manufacturers before selecting.
- Hole spacing on the arm mounting
100 mm x 100 mm (VESA compliant)
- Supportable Weight: Total weight of the monitor (without stand) and attaching
equipment such as a cable
- TÜV/GS approved arm or stand
• Please connect cables after attaching an arm stand.
Setup Procedure
1
Hold the upper and lower centers of the stand joint cover, and slide
sideways to remove it.
2
Lay the LCD monitor on a soft cloth spread over on a stable surface
with the panel surface facing down.
3
Remove the stand. (Prepare a screwdriver.)
Unscrew the two screws securing the unit and the stand with the screwdriver.
4
Attach the monitor to the arm or stand.
Secure the stand to the monitor with four screws using a screwdriver.
Stand mounting cover
arm
English