Northern Industrial Tools M35982E - Manual (Page 3)

COMPRESSOR LUBRICATION
CAUTION! Do not operate without lubricant or with inadequate lubricant.
Use of compressor without lubricant or inadequate lubricant voids all warranties.
Synthetic Lubricants
Synthetic lubricants are recommended after 50 hour break-in. Compressor life is greatly increased with the
use of synthetic lubricants. CAUTION! If you will be using synthetic lubricant, all downstream piping material
and system components must be compatible.
Suitable Viton
®, Teflon®, Epoxy (Glass Filled), Oil Resistant Alkyd, Fluorosilicone, Flourocarbon,
Polysulfide, 2-Component Urethane, Nylon, Delrin
®, Celcon®, High Nitrile Rubber (Buna N. NBR more
than 36 Acrylonite), Polyurethane, Polyethylene, Epichlorohydrin, Polyacrylate, Melamine,
Polypropylene, Baked Phenolics, Epoxy, Modified Alkyds
(
® indicates trademark of DuPont Corporation)
Not Recommended
Neoprene, Natural Rubber, SBR Rubber, Acrylic Paint, Lacquer, Varnish, Polystyrene, PVC, ABS,
Polycarbonite, Cellulose Acetate, Latex, EPR, Acrylics, Phenoxy, Polysulfones, Styrene Acrylonitile
(San), Butyl
Alternate Lubricants.
You may use petroleum-based lubricant that is premium quality, does not contain detergents, contains only
anti-rust, anti-oxidation, and anti-foam agents as additives, has a flashpoint of 440
°F (227°C) or higher, and
has a auto-ignition point of 650
°F (343°C) or higher.
See the petroleum lubricant viscosity table below. The table is intended as a general guide only. Heavy duty
operating conditions require heavier viscosities. Refer specific operating conditions to NorthStar Product
Support at 1-800-270-0810
Viscosity Grade Temperature
around
Compressor
ISO SAE
Below 40
°F (4°C)
100 30
40
°F to 80°F
(4
°C to 27°C) 100 30
80
°F to 100°F
(27
°C to 37°C) 150 40
Pump Capacities.
Refer to the following table for crankcase capacity
Item # Crankcase Capacity
45929 24 oz.
45930 36 oz.