NEC 140He - Manual (Page 275)

9-17
Rear Access Cover
To install or remove a PCI board, or to change cable connections of internal SCSI cable, you will need to remove the
rear access cover.
CAUTION
Observe the following instructions to use the server safely. Failure to follow these instructions
ay result in death or serious personal injury. See pages 1-3 to 1-8 for details. m
Be sure to power off the server before removing the rear access cover.
Removal
1. See the section "Preparing for Installation and Removal" described earlier to prepare.
2. Loosen the captive screws located on the rear of the cover.
3. Slide the rear access cover toward the rear of the chassis.
4. Lift the cover up and off of the chassis.
Captive screws