NordicTrack NTC3015.0 - Manual (Page 5)

5
ASSEMBLY
Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included tools and your own adjustable wrench and Phillips screw-
driver .
Use the part drawings below to identify the small parts used in assembly. The number in parentheses below
each drawing is the key number of the part, from the PART LIST on page 22. The number following the paren-
theses is the quantity needed for assembly. Note: Some small parts may have been pre-attached. If a part is
not in the parts bag, check to see if it has been pre-attached.
M6 x 8mm Button
Screw (59)–2
M8 x 22mm Button
Screw (54)–6
M4 x 16mm
Screw (57)–6
M4 x 22mm
Screw (60)–2
M4 x 16mm
Round Head
Screw (80)–4
M10 x 97mm Button Screw (77)–4
M8 x 54mm Button
Screw (52)–4
M10 x 54mm Button
Screw (56)–4
M10 Nylon
Locknut (65)–2
M8 Split
Washer (55)–14
M8 Nylon
Locknut (79)–4
M10 Split
Washer (71)–8
6.35mm
Spacer (62)—4
Curved
Spacer (76)—4