NordicTrack NTSY06990 - Manual (Page 6)

6
1.
Open the parts bag labeled ÒFRAME ASSEMBLY.Ó
Press a 2Ó Square Inner Cap (33) into the support
tube on the Main Upright (3).
Press a 2Ó x 3Ó Inner Cap (24) into the open end of
the Main Upright (3) and into each end of the
Stabilizer (5).
Attach the Stabilizer (5) to the Main Upright (3) with
two 3/8Ó x 3 3/4Ó Carriage Bolts (52) and two 3/8Ó
Nylon Locknuts (50). Do not tighten the Nylon
Locknuts yet.
1 Frame Assembly
33
24
24
5
50
Support Tube
50
24
3
52
2. Press a 2Ó Square Inner Cap (33) into the upper end
of the front leg on the Base (8) and into the upper
end of the Leg Lever (29).
Line up the bracket on the Base (8) with the holes in
the Main Upright (3). Insert a 3/8Ó x 4Ó Bolt (65)
through the bracket and the Main Upright from the
front. Secure the Bolt with a 3/8Ó Flat Washer (55)
and a 3/8Ó Nylon Locknut (50).
Do not tighten the Nylon Locknut yet.
Insert two 5/16Ó x 3Ó Bolts (78) through the bracket
and the Main Upright (3) from the side. Hand-tighten
two 5/16Ó Nylon Locknuts (21) onto the Bolts.
Do not tighten the Nylon Locknuts yet.
2
65
50 55
78
33
29
8
Front Leg
3
21
3. Attach the Leg Lever Lock (11) to the front leg with a
5/16Ó x 3Ó Bolt (78), three 5/16Ó Flat Washers (80) and
a 5/16Ó Nylon Jamnut (79). Do not overtighten the
Nylon Jamnut; it must be easy to turn the Leg
Lever Lock.
Attach the Leg Lever Bumper (6) to the front leg with
a #10 x 1Ó Tap Screw (7).
78
11
6
7
80
80
79
Front Leg
Before beginning assembly, make sure you
have read and understood the information on
page 5. This brief introduction will save you
much more time than it takes to read it!
3