NordicTrack NTSY06990 - Manual (Page 7)

7
4. Attach the Foot Plate (4) to the Base (8) with a 3/8Ó x
5 1/2Ó Bolt (57) and a 3/8Ó Nylon Locknut (50).
4
57
4
8
50
5. Place two Weight Bumpers (19) over the indicated
holes in the Stabilizer (5).
Insert the two Weight Guides (23) through the Weight
Bumpers (19) and the holes in the Stabilizer (5).
Attach the indicated Weight Guide (23) to the
Stabilizer (5) with a 3/8Ó x 2 1/2Ó Bolt (54), two 3/8Ó
Flat Washers (55), two 5/8Ó x 1/2Ó Pulley Bushings
(42), and a 3/8Ó Nylon Jamnut (63).
5
23
19
55
5
19
63
55
42
42
54
6. IMPORTANT NOTE: If you purchased the optional
weight expansion set, please refer to the userÕs
manual accompanying the set to assemble the
weights. After you have assembled the weights,
refer back to this manual and continue with ÒArm
AssemblyÓ found on the next page.
See the inset drawing. Press two Weight Inserts (77)
into the indicated holes in each Weight (26). Make
sure the large pin groove is oriented as shown.
Slide all of the included Weights (26) onto the two
Weight Guides (23). Make sure the Weights are ori-
ented correctly. The holes must be turned
towards the front of the unit, as shown.
Slide the Top Weight (16) with the pre-attached
Weight Tube (36) onto the Weight Guides (23). The
Weight Tube slides into the hole in the center of the
Weights (26).
Place the Top Frame (1) over the Weight Guides (23),
so the Weight Guides fit into the welded tubes on the
Top Frame.
Align the bracket on the Top Frame (1) with the holes
in the Main Upright (3). Insert two 3/8Ó x 3Ó Bolts (45)
through the holes. Tighten a 3/8Ó Nylon Locknut (50)
onto the lower of the two Bolts. Do not mount a
Locknut on the upper Bolt yet.
Attach the Weight Guides (23) to the Top Frame (1)
with two 3/8Ó x 1 3/4Ó Bolts (60), and two 3/8Ó Nylon
Locknuts (50). Go back and fully tighten all of the
Nylon Locknuts used in steps 1, 2 and 6.
6 45 1
60
50
50
23
16
36
26
Welded
Tubes
Holes
3
77
26
Large Pin
Groove