NAD C315BEE - Manual (Page 2)

VALUE
We are confident that the C315BEE will set new benchmarks
for performance, both measured and audible, at this affordable
price point. Unless you have power hungry speakers, listen at
dangerously loud levels, or have a very large room, the C315BEE
is likely to be all the amplifier you’ll ever need. Fundamental
specifications for noise, distortion, power, stereo separation,
and volume control tracking, are all class leading. Slightly more
esoteric measurements like transient intermodulation distortion,
dynamic crossover-notch distortion, power supply rejection and
square wave rise time would be impressive on an amplifier costing
many times its modest price.
The sonic result of this high technology is a relaxed and inviting
sound that digs out the subtle details in your favorite recordings
and presents them across a panoramic stereo sound stage. The
impressive dynamic power reserves make the C315BEE sound
both articulate and alive. The silent background and low distortion
gives a sense of solidity and presence to your music and brings
out the best your loudspeakers have to offer.
NAD Electronics International reserves the right to change specifications or features without notice. NAD is a registered trademark of NAD Electronics
International. All rights reserved. No part of this publication may be reproduced, stored, or transmitted in any form whatsoever without the written
permission of NAD Electronics International. © 08/07 NAD Electronics International.
www.NADelectronics.com
SPECIFICATIONS
Pre-Amp Section
Line level inputs
Input impedance (R+C)
Input sensitivity, rated power
Maximum input signal
Line level outputs
Output impedance
Tone Controls
Treble
Bass
Power Amp Section
Continuous output power into 8Ω
Rated Distortion (THD 20Hz - 20kHz)
Clipping power (maximum con. power 4/8Ω)
IHF dynamic power at 8Ω
IHF dynamic power at 4Ω
IHF dynamic power at 2Ω
Damping factor (ref. 8Ω, 1kHz)
Voltage gain
50kΩ / 100pF
200mV
7V
Tape Source Z + 600Ω
±5dB at 10kHz
±8dB at 100Hz
40W (16dBW)
0.02%
40W
90W (19.5dBW)
120W (20.8dBW)
180W (22.6dBW)
>160
39dB
Signal/noise ratio, A-weighted
THD + Noise
SMPTE IM
IHF IM
Headphone output impedance
Physical Specifications
Net Dimensions (W x H x D)
Gross Dimensions (W x H x D)*
Net Weight
Shipping Weight
* Gross Dimensions include volume knob / speaker terminals / connectors / feet.
Note: Installers should allow a minimum clearance of 2 - 4 inches for wire management.
ref. 1W 95dB
<0.02%
<0.02%
<0.01%
68Ω
17 1/8 x 2 3/4 x 9 1/2”
(435 x 70 x 242mm)
17 1/8 x 3 1/8 x 11 1/2”
(435 x 80 x 292mm)
11.5 lbs (5.25kg)
14.3 lbs (6.5kg)