Nostalgia Electrics CCP-510 - Manual (Page 8)

7
USING YOUR CIRCUS CART POPCORN MAKER™
1.
First, find a flat surface near an electrical outlet before starting. (Make sure your
cord is away from any water source. If needed, it is acceptable to use an extension
cord.)
Gather your popcorn making supplies; popcorn, seasonings, bowls or bags for holding the
popcorn, cooking oil, measuring cup and spoon. (See parts listed separately with assembly
instructions).
HERE’S A TIP:
Store all of your popcorn supplies in the handy storage compartment in base of unit,
then you will always be prepared and equipped to make hot, fresh theatre style
popcorn, anytime!
A B
2. Plug in your unit in the OFF position.
3. Make sure top unit is
properly seated in base unit.
4. Make sure kettle motor is plugged in.
5. Turn unit ON with switch on crown of machine.
Allow the unit to run for 3 – 5 minutes to heat up
kettle. Turn unit OFF.
6. By using the 1-tablespoon oil-measuring spoon
supplied with your OLD FASHIONED MOVIE
TIME POPCORN CART™, add your favorite
popcorn cooking oil to the kettle.
7. Then by using the
cup popcorn measuring
cup supplied, add popcorn to the kettle.
C
8. Turn the unit ON, close the door. In no time at all, you can hear the popping begin.
Then fresh hot popcorn will begin to burst out of the flip lids on the kettle, just like at
the theater!
When popping sound obviously slows down or stops, turn the unit OFF. Flip the kettle over
(see page 4) to empty the kettle. Repeat steps 6 thru 8 until desired amount of popcorn has
been popped.