Troubleshooting, Display, settings and power supply – Nikon L14 User Manual
Page 114
102
Tech
nic
a
l No
tes
Troubleshooting
If the camera fails to function as expected, check the list of common problems
below before consulting your retailer or Nikon-authorized service representative.
Refer to the page numbers in the right-most column for more information.
Display, Settings and Power Supply
Problem
Cause/Solution
A
Monitor is blank
• Camera is off.
• Battery is exhausted.
• Standby mode for saving power: press the
shutter-release button halfway.
• When flash lamp blinks red, wait until flash
has charged.
• Camera and computer are connected via USB
cable.
• Camera and TV are connected via A/V cable.
Monitor is hard to read
• Adjust monitor brightness.
• Monitor is dirty. Clean monitor.
• Monitor has dimmed to save power. Monitor
brightens when controls are used.
Camera turns off without
warning
• Batteries are low.
• Camera has turned off automatically to save
power.
• Batteries are cold.
Date and time of recording are
not correct
• Pictures recorded before clock was set, and
“Date not set” indicator blinks during shooting,
will have time stamp of “00/00/0000 00:00”;
movies will be dated “01/09/2007 00:00.”
Set the correct date and time from [Date] in
the setup menu.
• Check camera clock regularly against more
accurate timepieces and reset as required.
No indicators displayed in
monitor
[Hide info] is selected for [Photo info].
Select [Show info].
[Date imprint] not available
Camera clock has not been set.
14,
Date not appearing on pictures
even when [Date imprint] is
enabled
• d [Sports], l [Museum] or p [Panorama
assist] is selected from the scene mode menu.
• Movie mode is selected.
• [Continuous], [BSS] or [Multi-shot 16] is
selected for [Continuous].
Camera settings reset
Backup battery is exhausted; all settings were
restored to their default values.