Accessing the nncli, Tables, Table 1 nncli command modes – Nortel Networks NN46200-301 User Manual

Page 9

Advertising
background image

Command line interfaces

9

Table 1
NNCLI command modes

Command
mode

Prompt

Mode
name

Command/mode
to enter or exit mode

User EXEC

ERS-8300:5>

Exec

Default mode
when NNCLI is started

logout

to exit

Privileged
EXEC

ERS-8300:5#

privExec

enable

to enter

from User EXEC mode

disable

to exit

to User EXEC mode

Global
Configuration

ERS-8300:5(config)#

config

configure

to enter

from Privileged EXEC
mode

exit

to exit

to Privileged EXEC
mode

Interface
Configuration

ERS-8300:5(config-if)#

config-if

interface

to

enter from Global
Configuration mode

exit

to exit

to Global Configuration
mode

Accessing the NNCLI

When you first power up the Ethernet Routing Switch 8300, the default
interface is the Ethernet Routing Switch 8300 CLI. To switch from the CLI
to the NNCLI, you must change the NNCLI boot flag to

true

and save the

boot configuration file using the following commands:

ERS-8310:5# config boot flags nncli true

ERS-8310:5# save boot

You must reboot the switch for this change to take effect. After you reboot
the switch, access the NNCLI using Telnet, rlogin, or the local console port.
You can log in to the switch using your password and the default privilege
password

nortel

.

Use the following commands to:

log in to the software using the default user name and password

access Global Configuration mode

Login: xxxxx

Password: xxxxx

ERS-8310:5> enable

Nortel Ethernet Routing Switch 8300

Installation — AC Power Supply

NN46200-301

03.01

Standard

4.0

27 August 2007

Copyright © 2007, Nortel Networks

.

Advertising