Eizo 630lt-gr - Manual (Page 11)

3. SETTING UP the eClient
630LT-GR/630LT-GR-N
This chapter presents how to prepare for a connection with a WTS when the eClient
630LT-GR/630LT-GR-N starts up for the first time.
1.
Turn on the eClient 630LT-GR/630LT-GR-N.
The power indicator turns green and a picture appears on the screen.
NOTE
• When no picture is displayed, or when the message (No keyboard connected. /
No mouse connected.) is shown on the screen, please refer to “8.
Troubleshooting” on page 61. (In use of a stylus or a finger as an input device,
“No Mouse Connected!!” caution does not effect our operation.)
2.
“Touch panel calibration” is displayed.
Five targets are displayed on the screen. Press the targets with a stylus or a
fingertip to locate the center of the touch panel. If you accidentally touched the
screen in the wrong spot during calibration, you will distort the touch panel
calibration.
3. SETTING UP the eClient 630LT-GR/630LT-GR-N
11