Nortel Networks Meridian M3901 - Manual (Page 2)

Feature Operation
Note 1: Features must be enabled by your network
administrator. You only have access to the five
features or Auto Dial positions that appear on the
feature card of your telephone
.
Note 2: When activating features or programming Auto
Dial Keys, you have 30 seconds to complete the
key sequence or the process ends
.
For information on using your M3901 telephone when connected to a
Meridian SL-100 system, please consult the Meridian Digital Telephones
M3901, M3902, M3903, M3904 User Guide.
Explanations
For additional information on the operation of your telephone, please
consult the Meridian Digital Telephones M3901, M3902, M3903,
M3904 User Guide.
Auto Dial
store A
B A
use A
Hold
place a call on hold
return to a held call
Transfer
transfer a call A C
A
Conference
create a conference A
D A
correct an error or
receive busy tone
Last Number Redial
Ring Again
activate A
when notified A
cancel A
Speed Call
store A
E A
use A F
Volume Control
ringing (while the telephone is ringing)
handset (while on a telephone call)
Deactivate all active
features
£
Fx
Fx
Fx
Fx
Fx
Fx
Fx
Fx
Fx
Fx
Fx
Fx
Fx
Fx
Legend
Lift the handset, or press to receive dialtone.
Replace handset, or press to end the call.
Dial a number.
Press the Line Key.
Press the Hold Key.
Press the Goodbye Key.
Press the Feature Key.
Press the left side of the Volume Control Bar to lower
the volume. Press the right side to increase the volume.
Message Waiting and Call Status Indicator
On (steady light) A message is waiting.
Wink (slow flash) An incoming call is ringing.
Flash A call is on hold.
Off There is no message waiting, no call on hold, and
no incoming call.
Feature Activation Indicator
On (steady light) One or more features are active.
Flash A feature is being programmed and input is
required.
Remarks
A Press the Dial Pad Key ( ⁄ - fi) that corresponds to
Auto Dial or Feature number on your feature card
B Use the Dial Pad to enter the number (maximum of 31
characters). Be sure to include any required access
codes.
C Dial the number to which you want to Transfer the
call.
D Dial the number of the party that you want to add to
the Conference. You may repeat this process to add
up to six people to a Conference Call.
E Dial the 1 to 3 digit Speed Call code (ask your
network administrator if you are unsure about the
number of digits used on your network) followed by
the telephone number that the code represents
(maximum of 31 digits). Be sure to include any
required access codes.
F Dial the 1 to 3 digit Speed Call code.
Fx