Numark Industries TTUSB User Manual
Page 6
6
Setting the Anti-Skate Adjustment
In most cases, the Anti-Skate should be set to its minimum
setting. Anti-Skate compensates for inward tracking forces that
occur with certain cartridges when the stylus nears the center of
the record. If the turntable is experiencing excessive skipping
during back-cueing and scratching while nearing the center
spindle, try increasing the Anti-Skate in the increments indicated
on the dial. Start by adding an increment of 1, test its
performance, than increase it more, and so on.
IMPORTANT
Make sure that the felt slipmat is always placed on top of the
platter while using the turntable. Failure to use the slipmat may
cause damage to your media as well as damage to the turntable.
Remove the plastic cartridge cover (needle cover) before
operating the turntable.
BEFORE RETURNING THE PRODUCT, please contact Numark
Industries or your retailer for technical support. Contact
information can be found in the Safety Instruction Booklet
included with this product.