Removing the battery, Turning on and off the camera, Removing the battery turning on and off the camera – Nikon Coolpix S1100pj User Manual
Page 35
21
Inserting the Battery
First Ste
p
s
Removing the Battery
Turn the camera off and be sure that the power-on
lamp and the monitor have turned off before opening
the battery-chamber/memory card slot cover.
To eject the battery, open the battery-chamber/
memory card slot cover and slide the orange battery
latch in the direction indicated by the arrow (
1). The
battery can then be removed by hand (
2).
• Note that the camera, battery, and memory card
may become hot during use; observe due caution when removing the battery
and memory card.
Turning On and Off the Camera
To turn on the camera, press the power switch. The
power-on lamp (green) will light for a moment and the
monitor will turn on.
To turn off the camera, press the power switch again.
When the camera is turned off, both the power-on
lamp and monitor will turn off.
• If the camera is turned off, hold down the c button to turn the camera on in
playback mode (
C
Power Saving Function (Auto Off)
If no operations are performed for a while, the monitor will turn off, the camera will enter standby
mode, and the power-on lamp will blink. If no operations are performed for another three minutes,
the camera will turn off automatically.
To reactivate the monitor while the power on lamp is blinking, press any of the following buttons:
- Power switch, shutter-release button, A button,
c button or b (movie-record) button
• Camera enters standby mode in about a minute (default setting) during shooting or playback
mode. The time allowed to elapse before the camera enters standby mode can be changed from
the Auto off option (
A 153) in the setup menu (A 142).
• In projector mode (A 163), the camera enters standby mode in about five minutes (default
setting). The time allowed to elapse before the camera enters standby mode can be changed from
the Auto off option (