Niles Audio PHD60 - Manual (Page 11)

Figure 5. Connecting
a loudspeaker wire to the
PHD60/42/30 terminals.
Figure 6. Installing a PHD60/42/30 loudspeaker
onto its mounting bracket.
NILES AUDIO CORPORATION – 1-800-BUY-HIFI
9
FINISHING THE INSTALLATION
CONNECTING THE LOUDSPEAKER
1. At each loudspeaker, separate the loudspeaker wire so that at least 2 inches of each
conductor are free. Strip away 1/4 inch of insulation from each loudspeaker wire.
2. On each set of loudspeaker connectors, press down the spring-loaded lever, insert the
appropriate conductor, and then release the lever, as shown in Figure 5. Gently tug
on the loudspeaker wire to make sure it is held in place. If not, repeat this procedure
until it is. Make sure that only the bare wire is clamped in the connector.
NOTE: OBSERVE CORRECT POLARITY: POSITIVE (+) GOES INTO THE RED TERMINAL AND
NEGATIVE (–) GOES INTO THE BLACK TERMINAL. IF YOU ARE UNSURE OF WIRE POLARITY, SEE
THE SECTION
CHECKING LOUDSPEAKER PHASE ON PAGE 11.
3. If a mounting bracket was installed
on the wall, align each loudspeaker
with the two mounting holes (on its
bracket) and let it slide down into the
keyslot on the bracket to fasten it to
the wall, as shown in
Figure 6.
(CONTINUED ON NEXT PAGE)
DS00413BCN_0-PHD.indd 11 11/18/05 2:33:05 PM