Niles Audio PHD60 - Manual (Page 12)

Figure 7. Each PHD60/42 includes an adjustable Tweeter/Midrange Pod that can be rotated up
to 90 degrees for proper loudspeaker orientation and pivoted for precise imaging.
CONNECTING THE LOUDSPEAKER
(CONTINUED)
4. Connect the other end of the loudspeaker wires to the home theater receiver (or
amplifier) in the same way as steps 1 and 2.
5. Turn on the home theater receiver and calibrate all loudspeakers in the system
according to the receiver manufacturer’s instructions.
PHD60/42: SETTING THE TWEETER/MIDRANGE POD
Each PHD60/42 features an adjustable Tweeter/Midrange Pod on the front baffle for proper
loudspeaker orientation and precise imaging, as shown in
Figure 7. Adjust the pod as follows:
• For a vertical installation, no adjustments are required. The Tweeter/Midrage pod is
optimally set at the factory for this placement.
• For a horizontal installation (e.g., center-channel application), perform the following
steps to rotate the Tweeter/Midrage pod:
1. Using the enclosed Allen wrench, remove the four (4) Allen-head screws,
(see Figure 7).
2. Gently pull the pod away from the enclosure and rotate it 90° in either direction (see
Figure 7). Be careful not to disconnect any attached wires during rotation.
3. Place the pod back into the enclosure and reinstall the four (4) Allen-head screws.
• If desired, after vertical or horizontal installation, set the imaging by pressing the pod’s
edge to aim the drivers at the listening position (see Figure 7).
10
DS00413BCN_0-PHD.indd 12 11/18/05 2:33:07 PM