Nortel Networks 4060 - Manual (Page 14)

Set up the DECT Handset 4060
14
Figure 2: Battery charge status
Note: When new batteries are inserted, or the firmware on the
handset has been upgraded, a charge status icon will not display until
a complete charge cycle has been completed. However, when
partially charged batteries are inserted, then the charge status icon
will be shown immediately.
Register the handset
Before you can use the DECT Handset 4060, the handset must be
registered with the system. A system ID and handset registration code
may be required to complete the registration process. Contact your
system administrator for proper codes.
To register the handset with the DECT system:
1. Press the Menu soft key.
Fully charged - 80% to 100%
Partially Charged - 60% to 80%
Partially Charged - 40% to 60%
Partially Charged - 20% to 40%
No Charge - 0% to 20%.
Batteries are empty.
An alert tone sounds and the icon (frame) flashes.
x [
Menu
b M r
Nortel 5260
Robert Reid