NordicTrack NTBE01700 - Manual (Page 7)

7
3. Attach the Bench Leg (1) to the Bench Frame (5) with
two Bench Joint Plates (18), four 3/8” x 3” Bolts (21),
and four 3/8” Nylon Locknuts (11).
Note: Tighten all the M10 Nylon Locknuts (11)
used in steps 1-3.
3
1
11
18
5
21
18
4. Press two 1” x 1 1/2” Inner Caps (28) into each
Backrest Tube (27). Press two 1” x 1 1/2” Inner Caps
(28) into the Backrest Adjustment Bracket (35).
Lubricate a 3/8” x 7 1/2” Bolt (22). Attach the Backrest
Tubes (27) to the welded tube on the Backrest
Adjustment Bracket (35) with the Bolt and a 3/8”
Nylon Locknut (11). Make sure that the Backrest
Tubes are turned as shown. The indicated holes
are not centered in the Backrest Tubes but are
closer to one side. Turn the Backrest Tubes so the
holes are closer to the floor. Do not overtighten
the Nylon Locknut; the Backrest Tubes must pivot
easily.
4
28
11
35
Lubricate
Holes
Welded
Tube
28
28
22
27
5. Lubricate a 3/8” x 7 1/2” Bolt (22). Attach the Backrest
Tubes (27) to the welded tube on the Bench Frame
(5) with the Bolt and a 3/8” Nylon Locknut (11). Note:
Do not overtighten the Nylon Locknut; the
Backrest Tubes must pivot easily.
5
27
11
5
22
Lubricate
Welded Tube
6. Attach the Backrest (15) to the Backrest Tubes (27)
with four 1/4” x 2” Screws (4) and four 1/4” Washers
(30).
6
30
4
15
27