Network Technologies CRYSTALMON CM-WL17 - Manual (Page 10)

NTI CRYSTALMON TFT/LCD MONITOR
6
INSTALLATION
Mounting
Mount the CRYSTALMON as intended for the application.
Rack Mount
Secure the CRYSTALMON (model CM-RK17) to a rack using appropriate hardware through the holes provided (see
Fig. 1). Mount using at least two screws on each side.
Figure 1- Mount CM-RK17 to a rack
Wall Mount- with Arm
Mount the selected Wall Mount LCD Arm or bracket assembly to the wall. Attach the VESA mounting bracket from
the selected Wall Mount LCD Arm to the four holes located in the back of the CRYSTALMON using the M4 x 10mm
screws (4) provided. A set of holes is provided for either the 100mm bracket, or the 75mm bracket, whichever is
needed (see Fig. 2). (The 75-100mm mounting adaptor that is sometimes provided will not be necessary.) Follow
the instructions that came with the mounting arm or bracket to complete the assembly.
Front View of CM-RK17