Network Technologies CRYSTALMON CM-WL17 - Manual (Page 13)

NTI CRYSTALMON TFT/LCD MONITOR
9
Power Up
1. Connect the AC adapter to the power jack on the CRYSTALMON. Make sure the power connector is fully
inserted.
2. Plug the AC adapter into a power source and press the power button to power up the CRYSTALMON.
3. If the video source(s) are not yet ON, apply power to them at this time.
Figure 5- Connect the AC adapter
Power
Button
View of the control
buttons for the
CRYSTALMON
UNDERSIDE VIEW OF CRYSTALMON
Barrel
(Inside
barrel) (Outside
barrel)
Power Connector
2.5 mm x 5.5 mm Female
12VDC @ 5A OUTPUT
12 VDC
AC
ADAPTER
IEC Connector
IEC Power Cord
REAR VIEW OF CRYSTALMON
12VDC 5A - +
NTI NE TWORK TECHNOLOGIES INCORPORATED
Tel:330-562-7070 1275 Danner Dr Aurora, OH 44202 www.networktechinc.com
R
Fax:330-562-1999
DVI VGA