NEC NP40 - Manual (Page 33)

25
SELECT SOURCE AUTO
ADJ.
ON/STAND BY
FOCUS
LAMP
STATUS
POWER
➎ Correcting Keystone Distortion Manually
You can also correct the vertical keystone distortion manually.
NOTE: Manual keystone correction is not available when there is no signal received by any input.
Adjust the keystone distortion manually in the following cases:
• To fi ne tune Keystone correction even after performing the [Auto Keystone] adjustment
• When the menu setting for [Auto Keystone] is turned off
Adjusting with buttons on the cabinet
3. Projecting an Image (Basic Operation)
1. Press the SELECT ▲ or ▼ button with no
menus displayed.
The slide bar will be displayed for your adjust-
ment.
2. Press the EXIT button.
The slide bar will be closed.
Adjusting with the remote control
1. Press the MENU button.
The menu will be displayed.
2. Use the SELECT
▼ button to select [Setup -
General] and then press the ENTER button.
3. Select the Keystone function.
Use the SELECT ▼ button to select [Keystone].