NEC A700 JC-1736VMB - Manual (Page 17)

pq Geometry Controls
The Geometry controls allow you to adjust the curvature or angle of the
sides of your display.
u IN/OUT (pincushion): increases or decreases the curvature of the
sides either inward or outward.
r LEFT/RIGHT (pincushion balance): increases or decreases the
curvature of the sides either to the left or right.
q TILT (parallelogram): increases or decreases the tilt of the sides
either to the left or right.
p ALIGN (trapezoidal): increases or decreases the bottom of the
screen to be the same as the top.
x Color Control
9300°K/7500°K: selects one of two color settings.
? Tools
Provides a list of optional adjustments which include the following:
y DEGAUSS: Eliminates the build-up of stray magnetic fields which
alter the correct scan of the electron beams and affect the purity of the
screen colours, focus, and convergence. When activated, your screen
image will jump and waver a bit as the screen is demagnetised.
CAUTION: Please allow a minimum of 20 minutes to elapse between
uses of the Degauss function.
z DISPLAY MODE: Indicates the current frequency setting of the
monitor.
= IPM OFF MODE: Using this function the OFF MODE of the IPM
can be disabled.
– ON: The IPM works normally, all four stages of the energy
saving are used.
– OFF: The OFF MODE of the IPM is not used.
For standard computers and graphics boards you should keep the factory
setting ON.
E - 12 OSM Menus