Rear panel control & connections, Front panel controls & connections – Nady Systems RPA-2 User Manual

Page 6

Advertising
background image

REAR PANEL CONTROL & CONNECTIONS

6

REAR PANEL

(17) POWER SWITCH
Turns the unit ON or OFF. Always turn level controls down before
turning on the unit.

(18) VOLTAGE SELECTOR SWITCH

For selecting the proper voltage (115/230VAC) to match the power
supply in your area.

Note: To avoid damage to your unit, always make sure this switch
is set to the correct supply voltage. Damage caused by improper
use is not covered by the warranty.

(18)

(17)

(19)

(19) POWER CONNECTOR WITH FUSE HOLDER
This standard IEC power cord receptacle is used to connect the
AC power to your unit. It features a built-in fuse holder for a
5X20mm, (2.5A/250V for 115VAC, and 1.5A/250V for 230VAC
operation) fast-blow fuse. If the fuse continuously blows, shut off
the unit and have it serviced by qualified service personnel.

(20) EXTERNAL SPEAKER OUTPUT
1/4" (6.3mm) jack for connecting an external speaker cabinet to
the RPA-2. The connected speaker impedance must be 8 ohms
or greater. The RPA-2 external speaker output delivers 25W RMS
of power @ 8 Ohms.

CAUTION: Do not overload the RPA-2 with speaker loads less
than 8 ohms as this will degrade performance and may harm the
unit. Damage caused by improper use is not covered by the
warranty.

(21) LINE OUTPUT
This 1/4" (6.3mm) audio output is line level, post Master Volume,
designed for connecting to external recorders, mixers, or amplifi-
ers.

(20)

(21)

FRONT PANEL CONTROLS & CONNECTIONS

(13) EFFECTS SEND

This line level output can be connected to external recorders,
amplifiers, or effects processors. The signal is a mix of the
channel inputs determined by each Channel Gain control.

(14) EFFECTS RETURN
This input can be used to return the effected signal into the RPA-2
or it can be used as an auxiliary input. The input signal can be
adjusted by the Master Volume and the unit the Return jack is
connected to.

(13)

(14)

(15)

(16)

(15) AUXILLIARY OUTPUT
This line level output can be connected to external recorders,
mixers, or amplifiers.

(16) TAPE IN AND TAPE OUT
The Left and Right TAPE IN allows cassette recorders or CD
players to be added to the Main output. The RECORD OUTPUT,
with TAPE RCA jacks, provides signal output to a cassette deck or
home audio equipment.

Advertising