Nortel Networks T1 - Manual (Page 13)

YMLT1WN 3G Travel Router t1 User Guide
www.netcomm.com.au 13
NetComm Liberty Series - 3G Travel Router t1
Charging your battery
If you use the 3G Router until the battery has completely drained, it will power off. If this occurs, let the unit charge overnight.
Note: The battery must be fully charged before using your 3G Router for the first time.
To charge your battery please complete the following steps:
1. With the battery inserted into your 3G Router connect the supplied power adapter to the wall power outlet and to the micro USB socket on the
3G Router.
2. Leave it to charge until the power LED lights up solid Green.
Step 2 – Plug in the power
Connect the power adapter to the port on the back panel of your 3G Router. Then plug the other end of the power adapter into a wall
outlet or power strip.
Step 3a – Connect a computer or smartphone via Wireless
Using your wireless device, scan the wireless networks in your area and select the network called NetComm Wireless, then click connect.
When the security prompt enter the security key a1b2c3d4e5
Step 3b – Connect a computer via Ethernet
Press the Reset button on the Router and connect one end of the Ethernet cable to the WAN/LAN Port on the back panel of the 3G Travel
Router t1, and the other end to the RJ45 Ethernet port of the laptop or desktop PC you would like to use.
Default Settings
LAN (Management)
Static IP Address: 192.168.20.1
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.20.1
WAN (Internet)
WAN mode: DHCP
Wireless
SSID: NetComm Wireless
Channel: 11
Security: WPA-PSK
TKIP Key: a1b2c3d4e5
Modem Access
Username: admin
Password: admin