Assembly – NordicTrack NTTL39910 User Manual

Page 6

Advertising
background image

6

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly can be completed using the included
allen wrenches.

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.

3. Connect the Wire Harness (57) in the indicated location.

Push all of the excess wire up into the right Upright (95).
Make sure that the Wire Harness is fully connected.

2. While a second person holds the Handrail (91) near the

Uprights (95, 97), feed the Wire Harness (57) in the right
Handrail down into the right Upright. Pull the end of the
Wire Harness out of the lower end of the right Upright. If
there is a wire tie on the end of the Wire Harness, re-
move it. Set the Handrail on the Uprights.

Finger tighten four Handrail Bolts (99) into the Uprights
(95, 97) and the Handrail (91). Do not tighten the
Handrail Bolts yet. Be careful to avoid pinching the
Wire Harness (57).

Note: The CD Holder (86) and the Cup Holder (85) are
replaceable. If these parts become dislodged from the
Console Base (89), simply press them back into place.

97

91

86

89

85

99

57

2

1. Slide the Right and Left Uprights (95, 97) onto the brack-

ets near the front of the Frame (76). Make sure that the
Uprights are on the correct sides; the indicated holes
must be facing inward.

Raise the Right Upright (95) until the lower hole in the
front of the Upright is aligned with the upper hole in the
bracket on the Frame (76). Thread an Upright Bolt (96)
into the Upright and the bracket. Do not tighten the
Upright Bolt yet.

Repeat this step with the Left Upright (97).

95

96

96

76

97

57

3

Holes

1

95

95

ASSEMBLY

Advertising