Nvidia 680I LT SLI - Manual (Page 17)

Mainboard nForce 680i SLI/
Mainboard nForce 680i LT SLI
13
Connectors
Floppy Disk Drive Connector: FLOPPY
These mainboards provide a standard floppy disk drive connector (FDD) that supports 360KB/
720KB/ 1.2MB/ 1.44MB/ 2.88 MB floppy disk drives using a FDD ribbon cable.
Hard Disk Drive Connectors: IDE
These mainboards provide one IDE connector that supports Ultra ATA 33/66/100/133 IDE
devices. You can attach a maximum of two IDE devices, such as hard disk drive (HDD),
CD-ROM, DVD-ROM, etc. using an IDE ribbon cable.
In general, two IDE devices can be attached onto one IDE connector. If you attach two IDE
HDDs, you must configure one drive as the master and the other one as the slave. In this case,
one optical device i.e., CD-ROM, DVD-ROM…etc. should be attached to this connector as
well.
SATA II Connector: SATA A0/A1/B0/B1/C0/C1
The six SATA II connectors support 3 Gbps transmit rate, and one SATA connector only can
attach one SATA HDD of each time using SATA cables.
Pin Assignment Pin Assignment
1 GND 2 TX+
3 TX- 4 GND
5 RX+ 6 RX-
1
SATA A0/ A1/ B0/
B1/ C0/ C1
7 GND
Attention
The FDD/ IDE cable is designed and should be attached with a
specific direction. One edge of the cable will usually in color such
as red, to indicate that should line up with the header pin-1.
This mainboard supports RAID 0/ 1/ 0+1/ 5/ JBOD mode; refer
Appendix II for more information.