NEC N8406-022 - Manual (Page 46)

(English)
24
N8406-022
RST
20 21 22 23 24
1
2 3 4 5
6
7 8
Description
Name Description
1. Ejector Use this lever to install or remove a Switch Module in/from the Blade Enclosure.
2. RESET Switch Press this switch to restart the Switch Module.
Pressing the RESET switch reboots this Switch Module, loses the configuration
data not to save in the flash memory, and temporarily disconnects
communication with the network.
3. STATUS LED Indicates the Switch Module status.
Contact your service representative if it does not go on green in five minutes after the
Blade Enclosure is powered on.
4. ID LED The LED is intended to identify the Switch Module in the Blade Enclosure. The LED is lit
by software command.
5. Serial Port Used as a DB-9 management serial port.
6. LAN port RJ-45 connectors for Gigabit Ethernet uplink.
Indicate the link status and activity of each LAN port.
Off
Link not established
On (Green) Link established
7. LINK/ACT LED
Flash (Green) Data being transmitted or received
Indicate the link speed
Off 10Mbps
On (Green) 100Mbps
8. SPEED LED
On (Amber) 1000Mbps
NOTE: The Switch Module works with the Blade Enclosure. It does not
have a POWER switch.