Navigon 8100T - Manual (Page 39)

Basic Operations
Starting the NAVIGON 8100T
December 2008 NAVIGON 8100T User’s Guide 21
Version 1.1 NAVIGON, INC.
Using Standby Mode
Standby mode conserves battery power. When the device is switched back on from
Standby, the window that displayed when the device was set to Standby re-displays.
There are two ways to switch your device to Standby.
From the Main Window
On the M AIN W INDOW :
• Tap the (Standby) button.
From Any NAVIGON 8100T Window
• Press and hold the (On/Standby/Off) button for two (2) seconds, then
release.
Switching the Device Back On From Standby
To switch the Device back on:
• Press and hold the (On/Standby/Off) button for two (2) seconds, then
release.
Note: Use Standby mode only when your device will be unused for a very short time. If
left in Standby mode for an extended period, battery drain can occur as the GPS
receiver continues to draw power. For longer periods of inactivity, see “Turning off the
NAVIGON 8100T” on page 18.
Note: To further conserve battery power, the device resets itself if left in Standby
mode for a longer time.
Note: If a password has been created for the device, the E NTER P ASSWORD WINDOW
appears when the device is switched back on from Standby. See “Security” on page 31
for more on using passwords.