Nautilus BE STRONG NS 75X - Manual (Page 11)

11 Nautilus NS75X
Procedure:
ASSEmBLY
STEP 3
# component Qty
Step 3 Components:
8 Leg Press Top Link 1
9 Foot Plate Assembly 1
10 Leg Press Front Link Left 1
11 Leg Press Front Link Right 1
12 Leg Press Rear Link Left 1
13 Leg Press Rear Link Right 1
14 Leg Press Power Arm 1
15 Leg Press Power Link 1
29 Pivot Shaft 5
31 Hex Bolt - 1/2” x 3”L 2
38 Button Head Screw -
3/8” x 3/4”L w/ Thread Lock 15
39 1/2” Flat Washer 4
42 1/2” lock Nut 2
a. Attach all the Pivot Shafts (29) to the Leg Press Front
Link Right (11) and the Leg Press Rear Link Right (13)
using the hardware shown above.
B. Slide the shafts into position on the Main Base Assembly.
c. Slide the Leg Press Top Link (8) and the Leg Press
Power Arm (14) into position as shown above.
D. Position the Leg Press Front and Rear Link Left (10, 12)
over the shafts and attach with the hardware shown above.
e. Connect the Leg Press Power Arm (14) to the Leg Press
Top Link (8) using the Leg Press Power Link (15) and the
hardware shown above. Intsall short end of Leg Press
Power Link (15) up.
F. Attach the Foot Plate Assembly (9) to the Leg Press Top
Link (8) using the hardware shown above.
G. Tighten all hardware securely.
3/8" x 3/4"L w/ THREAD LOCK
1/2" x 3"L
38
38
10
9
8 39
29
15
14
13
12
11
31
42