Nautilus BE STRONG NS 75X - Manual (Page 9)

 Nautilus NS75X
Procedure:
ASSEmBLY
STEP 1
# component Qty
Step 1 Components:
2 Connecting Tube Assembly 1
5 Vertical Pulley Bracket 1
32 Hex Bolt - 3/8” x 3 1/4”L 1
33 Hex Bolt - 3/8” x 3”L 3
40 3/8” Flat Washer 8
43 3/8” Lock Nut 6
45 Hex Bolt - 3/8” x 3 1/2”L 2
a. Attach the Connecting Tube Assembly (2) to the gym
with hardware shown above. If using a NS200X,NS300X or NS600X
gym, remove the Cable Bracket and the rear bolt on the
gyms foot plate.
B. If using a NS200X,NS300X or NS600X attach the Vertical Pulley
Bracket (5) to the connecting Tube Assembly (2) using the hardware
shown above.
c. Tighten all hardware securely.
A. Attach the Connecting Tube Assembly (2) to the gym
with hardware shown above. If using a NS200X,NS300X or NS600X
3/8" x 3"L
3/8" x 3 1/4"L
3/8" x 3"L
3/8" x 3"L
LEG PRESS CABLE
NS 700X
RIGHT SIDE ONLY
NS200X,NS300X & NS600X
RIGHT OR LEFT SIDE
(OPPOSITE OF WEIGHT
STACK)
REMOVE CABLE
BRACKET
LEG PRESS CABLE
43
40
2
33
33
40
5
33
43
2
32
Note: If NS75X is attached to NS700X
use 3/8” x 3 1/2” Hex Bolt