Eizo FlexScan L665 - Manual (Page 22)

English
22
4. ADJUSTMENT
4.
To adjust the output signal range (Dynamic Range) of the signal.
→
Use the <Range Adjustment> (p.37) of
<ColorManagerment> menu.
This controls the level of output signal range to display the whole color gradation
(256 colors).
[Procedure 1]
Push the Auto adjustment button on the front panel while displaying the <Range
Adjustment> menu to automatically adjust the range. The screen blanks for a
moment, and adjusts the color range to display the whole color gradation of the
current output signal.
[Procedure 2]
Pressing Auto adjustment button while displaying the contrast/brightness
adjustment screen (appeared by pressing the control buttons directly) adjusts the
range automatically. (Contrast and Brightness will not be adjusted.)
5.
To smooth the blurred texts of the enlarged screen of the lower
resolutions.
→
Switch the <Smoothing> setting. See p.23
6.
To set the Contrast of the screen.
→
Use the <Contrast> adjustment.
This controls the brightness for the each color (red, blue and green) at the same
time.
Select <Contrast/Brightness> and adjust by using the right and left buttons.
NOTE
• Percentage except 100 % may cause undisplayable color tone.
• During selecting the <sRGB> of <ColorManagement>, contrast cannot be
adjusted.
7.
To Set the Brightness of the screen.
→
Use the <Contrast> adjustment.
The brightness of the entire screen is controlled by changing the brightness of the
backlight.
Select <Contrast/Brightness> in the screen menu and adjust by using the up and
down buttons.
NOTE
• Directly pressing the up and down buttons also adjusts the contrast and
brightness. Press the “Enter” button to save and exit the settings after the
adjustment.