Netopia D3232 IDSL - Manual (Page 18)

2-18 User’s Reference Guide
N N N Nee e etttto o o op p p piiiiaa a a D D D D----S S S See e errrriiiiee e essss D D D DS S S SLLL L D D D DS S S SU U U U ssssttttaa a attttu u u ussss lllliiiig g g gh h h httttssss
The figure below represents the Netopia D-Series status light (LED) panel.
Netopia D-Series LED front panel
The following table summarizes the meaning of the various LED states and colors:
8-por t Ethernet hub Eight 10Base-T Ethernet jacks. You will use one of these to configure the
Netopia D-Series. For a new installation, use the Ethernet connection.
Alternatively, you can use the console connection to run console-based
management using a direct serial connection. You can either connect your
computer directly to any of the Ethernet por ts on the Netopia D-Series, or
connect both your computer and the Netopia D-Series to an existing Ethernet
hub on your LAN.
When this happens... the LEDs...
The corresponding line passes super visor y traffic between
the Digital Subscriber Line Access Multiplexer (DSLAM) and
the Netopia D-Series 2 or 8 flashes yellow .
The WAN inter face is operational 3 or 9 is green .
The line is unavailable 3 or 9 flashes red .
The WAN on Channel 1 has carrier 4 or 10 is green .
Data is transmitted or received on the WAN on Channel 1 4 or 10 flashes yellow .
The WAN on Channel 2 has carrier 5 or 11 is green . (D3232 only)
Port Description
2 3 4 5 6 7 8 9 10 11 12 13 14 15 16171819 20 21
Management
Ready
Channel 1
Link/Receive
Console Auxiliar
y
Collision
Traffic
WAN 1 WAN 2 Ethernet
Power
1
Channel 2
Management
Ready
Channel 1 Channel 2