NordicTrack FUTURA NTS78740 - Manual (Page 10)

10
11. Insert the Resistance Bar (9) between the
Crossbar Guides (15), and center it on the
Crossbar Block (not shown).
Press a Pulley Bracket (10) onto the Resistance
Bar (9). Screw a 3/8” x 38mm Tension Screw
(117) into the Pulley Bracket a couple of turns.
Make sure the hexagonal hole in the Screw is
on the outside of the Bracket.
Attach a Tether (70) to the Pulley Bracket (10) at
the upper hole, with an M10 x 64mm Button Bolt
(80), an M10 Thick Washer (54), and an M10 Nylon
Locknut (103).
Repeat on the other side of the Resistance
Bar (9). Then, tighten the lower M10 x 152mm
Bolt (86) used in step 10.
12. Hold a Large Pulley (14) inside the Upper Cable
(121). Attach the Pulley to a Pulley Bracket (10)
with an M12 x 58mm Button Bolt (87) and an M12
Nylon Locknut (13).
Make sure that the Cable is
routed as shown in the CABLE DIAGRAM on
page 19.
13. Hold a Large Pulley (14) inside the Upper Cable
(121). Attach the Pulley to the other Pulley
Bracket (10) with an M12 x 58mm Button Bolt
(87) and an M12 Nylon Locknut (13).
Make sure
that the Cable is routed as shown in the
CABLE DIAGRAM on page 19.
Tighten the two 3/8” x 38mm Tension Screws
(117) an equal number of turns.
11
12
15
70
103
117
117
80
9
10
10
14
121
13
87
13
10
14
121
13
87
54
14. Attach the Leg Lever (56) to the Leg (5) with a
Leg Station Pin (60). Slide a Cotter Pin (113) onto
the Leg Station Pin.
14
56
60
113
5