NXP Semiconductors ISP1183 - Manual (Page 18)

NXP Semiconductors
UM10044
ISP1183 Low-Power USB Peripheral Controller PC Eval Kit
Please be aware that important notices concerning this document and the product(s)
described herein, have been included in the section ‘Legal information’.
© NXP B.V. 2007. All rights reserved.
For more information, please visit: http://www.nxp.com.
For sales office addresses, email to: [email protected].
Date of release: 6 February 2007
Document identifier: UM10044_4
12. Contents
1. Introduction .........................................................3
2. System requirements ..........................................3
3. Jumper settings on the ISP1183 eval board .....4
4. I/O mapping..........................................................5
5. Installing hardware, firmware, INF and driver...6
6. Using the host applet ..........................................6
7. Testing control endpoints using standard USB
compliance tool ...................................................7
8. Schematics ........................................................ 10
9. Bill of materials.................................................. 14
10. References ......................................................... 16
11. Legal information .............................................. 17
11.1 Definitions............................................................ 17
11.2 Disclaimers.......................................................... 17
11.3 Trademarks ......................................................... 17
12. Contents............................................................. 18