Nikon LS-30 - Manual (Page 16)

- 16 - Parts and Accessories: Status LED
Status LED
The scanner’s status is shown by the LED on the front panel.
When the status LED is on and glowing steadily (READY):
the power is on but no operation is being performed.
Adapters can be exchanged and film inserted. If the com-
puter to which the scanner is connected is off, the scanner
can be turned off.
When the status LED blinks slowly (BUSY):
scanning is in progress or the scanner is initializing after
having been turned on. Do not turn the scanner off, remove
or insert adapters, or eject or insert film.
When the status LED flashes rapidly (ERROR):
a communications error has occurred or there is a problem
with the scanner. If this condition persists, close all applica-
tions and turn off the computer, then turn off the scanner.
Wait at least five seconds before turning the scanner on
again and restarting the computer.
Status LED
Note: The LED may sometimes blink erratically, but this does
not indicate a malfunction.
✔
Caution: Do not insert or remove adapters while the LED is
blinking, as this could cause the scanner to malfunction.