NordicTrack C2300 30601.0 - Manual (Page 7)

7
2. Attach the four Base Pads (81) (only three are shown) to
the base of the Uprights (85) with four 1” Tek Screws (82)
and four Plastic Spacers (101). Note: One replacement
Base Pad may be included. Use the Base Pad to replace
any Base Pad that becomes worn.
With the help of a second person, carefully tip the tread-
mill down so the four Base Pads (81) are resting on the
floor and the Uprights (85) are in a vertical position.
85
82
82
81
81
101
101
101
55
2
4. With the help of a second person, set the console assem-
bly on the right Upright (85) and the left Upright (not
shown).
Make sure that no wires are pinched. Attach
the console assembly with four Console Bolts (72) and
four Star Washers (67) (only one side is shown).
Start all
four Console Bolts before tightening any of them.
72
67
85
Console
Assembly
4
3. Remove the band securing the Upright Wire Harness (73)
to the right Upright (85). Have a second person hold the
console assembly near the right Upright.
Connect the Upright Wire Harness (73) to the wires ex-
tending from the console assembly.
Make sure to con-
nect the connectors properly (see the inset drawing).
The connectors should slide together easily and
snap into place. If the connectors do not slide together
easily and snap into place, turn one connector and try
again.
IF THE CONNECTORS ARE NOT CONNECTED
PROPERLY, THE CONSOLE MAY BE DAMAGED
WHEN THE POWER IS TURNED ON. Insert the connec-
tors into the right Upright (85).
73
85
Console
Assembly
73
3