NordicTrack C2300 30601.0 - Manual (Page 9)

9
If you purchase the optional chest pulse sensor (see page 26), follow the steps below to install the re-
ceiver included with the chest pulse sensor.
1. Make sure that the power cord is unplugged. Remove
the indicated Screw (7) and the Access Door (95) from
the left side of the Console Back (98).
2. Connect the wire on the receiver (A) to the indicated wire
extending from the Console Back (98). Hold the re-
ceiver so the small cylinder is oriented as shown and
is facing the Console Back. Attach the receiver to the
plastic posts on the Access Door (95) with the two in-
cluded small screws.
3. Make sure that no wires are pinched. Reattach the
Access Door (95) with the Screw (7). Discard the other
wires included with the receiver.
A
98
Small
Cylinder 7
95
Wire
Small
Screws
8. Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen
wrench in a secure place; the allen wrench is used to adjust the walking belt (see page 30).
To protect the
floor or carpet from damage, place a mat under the treadmill.
7. Remove the Shock Pin (108) from the lower end of the
Shock (107).
Plug in the power cord as described on page 10, and
turn on the power as described on page 12. Next, press
the Incline increase and decrease buttons until the ball
on the bracket is aligned with end of the Shock (107).
Then, press the end of the Shock onto the ball. Note: It
may be necessary to press the end of the Shock onto the
ball while the Frame (55) is moving.
See drawing 7a. Insert the end of the Shock Pin (108)
into two of the small holes in the end of the Shock (107).
Then, rotate the Shock Pin until it clips onto the Shock.
Press the Incline decrease button until the treadmill is at
the lowest incline level. Unplug the power cord. With the
help of a second person, lower the Frame (55) to the floor.
107
108 107
108
7
85
55
Bracket
Bracket
7a