Native Instruments B4 II - Manual (Page 53)

B4 II – 53
Rig-Kontrol-2 Active: This is for proud owners of the Native Instruments Rig-
Kontrol 2. Activate this option, if you want to control the B4 with the Rig-
Kontrol. Please be sure that no Guitar Rig is running when activating Rig-Kontrol
for the B4. It cannot be used for both at the same time. The default state of
this control is off. Furthermore you can only use the Rig-Kontrol 2 with your
B4 in standalone mode.
Audio Input Active: This control enables/disables the audio input from your
sound hardware into the B4 standalone version. It is only available for the
standalone version.
Audio/MIDI Setup: This brings up the setup window for selecting the audio-
and MIDI interfaces. Please refer to the respective manual sections in the
first part of this text for further information. This control is not available in
the plugin version of B4. The host software takes care of all things audio and
MIDI for the B4 plugin.
Controller Options
Xk3 MIDI Compatibility: Switch on if you want to control the B4 with the
Hammond Xk3 controller hardware. This piece of kit uses its own protocol to
communicate with the B4.
Invert MIDI Drawbars: When using a MIDI controller to control the drawbars,
this control inverses the effect of pulling/pushing the drawbar.
CC Dump On Program Change: When this switch is active, every received program
change sends out the current value of all panel controls as MIDI controller
messages. You can use this if you have MIDI controller hardware with
endless
encoders displaying the current value of individual controls. The controller
dump will happen when you switch a preset via the B4 interface and if you
initiate a program change via your MIDI hardware or sequencer software.
Drawbar options