Network Technologies KEEMUX-P2 - Manual (Page 6)

4
Units with audio support (optional)
Connect the 3.5mm plug from speakers to the 3.5mm jack labeled "AUD OUT". Attach SA-xx-MM audio cables (purchased
separately) between the audio port on each CPU and the 3.5mm audio jacks marked "AUD 1" on the KEEMUX switch. Be sure
to connect the audio cables from each CPU to audio jacks of the same number as the keyboard, mouse, and video cable ports
connected to.
( See Fig. 5).
Power-Up Sequence
1. The KEEMUX-P2 is powered by the CPUs it is connected to (unless using a power supply with an option).
2. Turn ON power to monitor attached to the KEEMUX-P2.
3. Turn ON power to either or both CPU(s) attached to the KEEMUX-P2.
Power-Down Sequence
1. Turn OFF CPUs attached to the KEEMUX-P2.
2. Turn OFF power to monitor attached to the KEEMUX-P2.
USING THE NTI SWITCH
The switch can be operated by the front control panel or by keyboard control.
Front Panel Control
1. Pressing the touch switch on the front panel will toggle between CPU 1 and CPU 2 and connect the selected CPU to the
keyboard, monitor and mouse.
2. Holding down the "CPU SELECT" button for more than 2 seconds will cause the switch to cycle through 3 extended modes of
operation: SCAN, BROADCAST, and COMMAND (see below for Command, Scan and Broadcast Mode sections). Release
the button when the desired mode has been selected.
Fig. 5
Rear View of KEEMUX-P2-AUD
AUD OUT AUD 2
Speakers
3.5mm Stereo
Plug
3.5mm Stereo
Jack
Audio Port
line
out
ONE WILL BE MARKED "line
out" ,"spkr", "headphones"
OR WITH THIS SYMBOL
3.5mm Stereo
Plug 3.5mm Stereo
Plug
SA-xx-MM
Rear View of
PS/2 CPU
PC 2 VIDEO 1 2
4 3
6 5
USER
1 2
4 3
6 5
1 2
4 3
6 5
PC 1 VIDEO MONITOR
PC 1 PC 2
PWR
1 2
4 3
6 5
1 2
4 3
6 5
1 2
4 3
6 5
MOUSE
KYBD
AUD 1
1 2
4 3
6 5
1 2
4 3
6 5
1 2
4 3
6 5
1 2
4 3
6 5
1 2
4 3
6 5
1 2
4 3
6 5