NEC 17600SUG05 - Manual (Page 47)

Using the Recording Options
You can use the options below while recording. To hear these options
while recording, just press zero. NVM-Series pauses the recording and
lists the options. You can select an option any time during the listing.
Note: NVM-Series does not play the recording options when you
press zero while recording a reply to a message or while record-
ing a message after making an intercom call. Automated
Attendant callers may be able to can press ❋ to pause their
recording, then press zero to hear the recording options.
1. Press ❋.
● You hear: Recording has been
paused. To continue recording press
the star key. You can continue record-
ing or select another recording option.
1. Press ❋.
● You hear: Recording, beep.
2. Start speaking after the beep.
You can do this only if you started record-
ing by pressing
R or RS , or if you are
recording a comment to a message you are
going to forward.
1. Press
B (2).
■ The recording plays, then pauses. You
can press ❋ to continue recording or
you can select another option.
■ If you wish, you can edit the recording
while its playing: Just press ❋ to pause
the playing, then press ❋ again to re-
record from that point on.
■ The backup time is normally 5 seconds.
To B ackup a few sec-
onds and listen to the
recording
To continue recording
after a pause
To pause recording
43
Recording and Checking Messages
17600sug05.qxd 3/13/01 12:01 PM Page 43