Nexus 21 NX2 - Manual (Page 9)

SERVER
2.1 Location of the Server
The Server must be mounted on a dry, flat and vertical surface
below deck , at least 500 mm (20") from radio receiving
equipment.
Locate the Server in the centre of the boat and close to the
electrical panel if possible.
2.2 Installing the Server
Remove the Server cover from the base plate by removing the
two screws. Drill the 4 screw holes using a 2.8 mm (0.11") drill.
Mount the Server using the 4 mounting screws.
Apply silicon paste on the screw terminal. Connect the 8 m Nexus
Network cable labelled number 5 and supplied with cable
protectors to the Server on pins 5, 6, 7, and 8. Match the colour
codes for each wire.
8