NComputing X550 EN - Manual (Page 36)

X550 User Guide
Page 36
The "System Settings" item shows the following settings for the terminal services
software. Double-clicking on the name of the setting allows you to adjust it, unless it is
read-only, which is specified below.
•
Maximum number of stations (incl. Host): the maximum number of sessions
the vSpace software is configured to support. This number includes the host PC.
This setting is read-only.
•
Current number of additional stations: the number of additional stations. This
setting is read-only.
•
This machine: the name of the host PC. This setting is read-only.
• This user: the currently logged-in user’s username. This setting is read-only.
•
System uptime: how long the system has been up. This setting is read-only.
•
Start stations at boot?: whether or not the stations start when the host PC
boots. You can set this either on or off.
•
Allow Shutdown/Reboot from stations: whether or not the stations are given
the option to shutdown or reboot the host PC. You can set this either on or off.
•
X550 card video mode settings: The video mode settings for the X550 stations.
You can set this to either 800x600 or 1024x768.
•
Allow only the last logged in user the shutdown of the system: whether or
not it is required that there is one and only one user logged on for the system to
be shut down or rebooted. You can set this either on or off.
•
Delay until shutdown (seconds): the default amount of time after a shutdown
command is issued until the shutdown occurs. You can set the number of
seconds.
•
Disable Send Broadcast Message: whether or not the administrator has
disabled broadcast messages. You can set this either on or off.
•
Support WTSAPI32 Interface: whether or not the terminal services software has
turned on support for the WTSAPI32 application interface. At times, this setting is