Numark Industries DM1720X - Manual (Page 8)

DM1720X
DM1720X REAR PANEL DIAGRAM...
1
2 3 4
6
7 9 7 7 7 7 9 9
11
10
5
1. GND is the grounding lug for turntables 1, 2 and 3
(phono inputs on Channels 1, 2 and 3). Always use this
connection (your turntable cable should have a grounding
wire).
2. The Stereo Main Outputs are low-impedance RCA
connectors controlled by the Master fader.
3. The Tape Outputs are low-impedance unbalanced
RCA jacks which output the program mix and allow you to
connect any recording device.
4. The Stereo Zone Outputs are low-impedance
unbalanced RCA jacks controlled by the Z o n e L e v e l
controls.
5. Mic is the mic input for the Mic Channel.
6. Mic is the mic input for the Mic on Channel 4.
7. Channels 1-5 Line Inputs are unbalanced RCA
jacks. The Line Input is selected with the toggle switch
on the front panel. You can connect stereo audio from HiFi
VCRs, cassette and reel-to-reel tape decks, DAT
machines, CD players, laser discs, tuners, even
synthesizers or other mixing consoles.
N O T E : Plug mono audio sources into both Left and
Right inputs using a “Y” cable connector.
9. Phono Inputs on Channels 1, 2 and 3 use
unbalanced RCA jacks. Your input signal is fed directly to
the D M 1 7 2 0 X's high-quality RIAA phono preamplifiers so
use this position only for moving magnet cartridges. Line
level sources will overload the sensitive phono preamps
and will sound very bad.
10. AC Cord. See safety precautions on page 3 for
proper treatment of the power cord.
11. Voltage Selector. Set this for the appropriate
voltage in your area
Numark - The Proven Leader in DJ Technology
©1998 Numark Industries 8 http://www.numark.com