Napco Security Technologies GEM-DXRP2 - Manual (Page 11)

11
Disarming the System
1 Upon entry, the keypad sounder will pulse as a reminder to disarm the panel. The red
ARMED light will be on and the window will alternately display "DISARM" and "XXXSEC",
where "XXX" represents the entry time remaining in 10-second steps. During the final 10
seconds, the sounder will pulse (rapidly) a warning signal.
2 Enter your User Code and press
D.
The sounder will silence and the red ARMED light
will go out, indicating that the system has been disarmed.
• If you enter an invalid code, the keypad display "Wrong Code" Re-enter your code
immediately.
Alarm Indication / Silencing an Alarm
If the red ARMED light is flashing and “ALARM” is displayed, an alarm occurred while you
were out. Proceed with caution! If you suspect that an intruder may still be on the premises,
leave immediately and call authorities from a neighbor's phone.
To silence an audible alarm:
1 Enter your code and press
J
. After the system is disarmed, the window will continue to
display “ALARM” followed by the zone(s) violated.
2 To reset the display, note the zones violated, then press C .
T U R N I N G O F F T H E AL AR M ( D I S AR M I N G ) W H E N R E T U R N I N G
A C O N
DISARM/
XXXSEC
A C O N
Wrong/
Code
A C O N
ALARM/
ZONE02