Northern Industrial Tools 10000 BDG - Manual (Page 19)

Installation / Initial Set-Up
19
2. See below for a possible mounting configuration.
3. If the control box is not located on the correct side for your application, you
can rotate it to the opposite side:
1) Remove the fan vents.
2) Remove the four drive-end bracket bolts.
3) Rotate the drive-end bracket 180°.
4) Re-torque bolts to 17 ft-lb.
5) Reinstall the fan vents
6) Remove the four screws at the base of the control box and rotate the
control box 180°.
7) Replace screws at base of the control box.
8) The voltmeter is now on the back of the machine instead of the front