NordicTrack C2270 NTL12950 - Manual (Page 8)

8
If you have purchased an optional chest pulse sensor,
follow step 6 to install the receiver included with the
chest pulse sensor. If you have not, go to step 7.
6. Place the console assembly face-down. Be careful not to
scratch the face of the console. Remove the indicated
3/4” Screw (7) and the Access Door (95) from the left side
of the Console Back (96).
Connect the wire on the receiver (A) to the indicated wire
extending from the Console Back (96).
Hold the receiver
so the small cylinder is oriented as shown and is fac-
ing the Console Back. Attach the receiver to the plastic
posts on the Access Door (95) with the two included small
screws.
Make sure that no wires are pinched. Reattach the
Access Door (95) with the 3/4” Screw (7). Discard the
other wires included with the receiver.
6
A
96
Small
Cylinder
7
95
Wire
Small
Screws
7. Cut the tie securing the wires to the Upright Base (85).
Have a second person hold the console assembly near the
Upright Base. Connect the Upright Wire Harness (73) and
the Pulse Wire (74) to the wires extending from the console
assembly.
The connectors should slide together easily
and snap into place. If they do not, turn one connector
and try again. Insert the connectors into the console as-
sembly. If necessary, remove the right accessory tray (not
shown) from the console assembly.
Connect the Upright Ground Wire (113) to the ground wire
extending from the console assembly. Make sure that the
wires are fully inserted into each other. Insert the ground
wires into the console assembly. Reinsert the right acces-
sory tray (not shown) into the console assembly if neces-
sary.
85
73
Console
Assembly
Ground
Wire
74
113
7
73
74
5. Cut the tie securing the Pulse Wire (74) to the Upright
Base (85). Hold the Pulse Bar Assembly (69) near the
crossbar on the Upright Base (85). Connect the Pulse
Wire to the wire in the Pulse Bar Assembly.
The connec-
tors should slide together easily and snap into place.
If they do not, turn one connector and try again. Insert
the wires into the crossbar.
Open parts bag B. Attach the Pulse Bar Assembly (69) to
the crossbar on the Upright Base (85) with four Pulse Bar
Bolts (127) and Star Washers (67). Start all four Pulse Bar
Bolts before tightening them.
Make sure that no wires
are pinched.
85
74
127
127
69
67
5
67
74