Nikon Coolpix S52c - Manual (Page 43)

31
Using the Flash
Bas
ic Ph
otography an
d Pl
ayba
ck
: A
u
to
Mod
e
B
Shooting When Lighting Is Poor and the Flash Is Disabled (W)
• Use of a tripod is recommended to stabilize the camera during shooting and avoid the effects of
camera shake. Turn vibration reduction ( A 105) off when using a tripod.
• The E indicator is displayed when the camera automatically increases sensitivity. Pictures taken
when E is displayed may be slightly mottled.
• When E is displayed and higher sensitivity is applied, noise reduction may be automatically
applied as pictures taken are recorded; results in increased recording times.
B
Note on Using the Flash
When using the flash at a wide-angle zoom position, reflections from dust particles in the air may
appear as bright spots in pictures. To reduce these reflections, set the flash mode to W (Off) or zoom
in on the subject.
C
The Flash Indicator and Flash Lamp
The flash indicator and flash lamp indicate flash status
when the shutter-release button is pressed halfway.
• On: Flash will fire when picture is taken.
• Blinks: Flash charging. Wait a few seconds and try
again.
• Off: Flash will not fire when picture is taken.
If the battery is low after pictures are taken using the
flash, the monitor display will turn off, and remain off,
and the flash lamp will blink until the flash is fully
charged.
C
The Flash Mode Setting
The default setting is U (auto), except in some scene modes and one-touch portrait mode.
If the flash mode is adjusted in any scene mode or one-touch portrait mode, the setting reverts to
the default setting whenever another shooting mode is selected or the camera is turned off.
C
Red-Eye Reduction
This camera uses advanced red-eye reduction (“In-Camera Red-Eye Fix”). The flash fires repeatedly at
low intensity before the main flash, reducing red-eye. The camera then analyzes the picture; if red-
eye is detected, the affected area will be processed to further reduce red-eye before the picture is
saved. Note that because there is a slight lag between the shutter-release button being pressed and
the picture being shot, this mode is not recommended when a quick shutter response is required.
The time before the next picture can be shot also increases slightly. Advanced red-eye reduction
may not produce the desired results in all situations. In extremely rare instances, areas not subject to
red-eye may be affected by advanced red-eye reduction processing; in these cases, choose another
mode and try again.