Navigon PNA 2100 max - Manual (Page 26)

Getting Started
Preparing your NAVIGON 2100 max | 2120 maxfor use
10 NAVIGON 2100 max | 2120 max User’s Guide December 2008
NAVIGON, INC. Version 2.1
Preparing your NAVIGON 2100 max | 2120 maxfor use
Charging the battery
• Connect the car charger cable to the navigation device and to the vehicle’s ciga-
rette lighter.
The LED of the NAVIGON 2100 max | 2120 max indicates the current battery
charge. The LED lights:
• No light, the battery has no charge.
• Orange during charging.
• Green when the battery is fully charged.
Power Interruptions
When power to the device is interrupted, the NAVIGON 2100 max | 2120 max can be
configured to put itself into Standby mode to save power. This occurs when the device
is on and is disconnected from a power source, such as:
• The vehicle cigarette lighter, or
• A wall outlet.
With this option, after a power interruption, the device waits 30 seconds, then puts
itself into Standby mode. When one of the above power interruptions occur, the follow-
ing message displays a 30 second countdown:
Tap:
• OK or wait until the 30 seconds countdown completes to allow the device to enter
Standby mode.
• Cancel to end the countdown and continue using the device.
Caution! Please be sure to read, understand, and follow the safety information in
“Important safety information” on page 8.
Note: A 12 volt car charger cable is included with your device. An A/C wall charger is
also available as an optional accessory. Visit our web store www.navigonusa.com/store/ .
For more information on setting this option, see Automatic Standby in “General Set-
tings” on page 115.