Nlynx MinIT6000 - Manual (Page 126)

Possible Cause 4.4.2
Improper configuration of the subsystem used for the virtual devices.
Solution
Our product emulates different IBM terminals depending on the color and width
selection. For 132 wide configurations, the MinIT6000 emulates an IBM 3477 terminal.
For monochrome 80 wide, it emulates a 5251. For 80 wide color configuration it
emulates 3179. This means your subsystem (typically, QINTER) must allow a 3179. To
verify this:
1. On the AS/400 command line, type WRKSBSD *ALL followed by the <enter> key.
2. Locate the subsystem you're using for the virtual devices, select the option Display,
by typing a 5 and then <enter>.
3. On the next display, select the option Workstation type entries by typing a 5 and
then <Enter>.
4. On the next display, verify that you see a "Type" of "*all", or a type of "3179".
5. If so, select option Display workstation type details by typing a 5 and then
<Enter>.
6. On the next display you should see an appropriate value for the "Maximum active
jobs" parameter. You can make changes in one or both cases by typing CHGWSE
(or ADDWSE), followed by the <Enter> key, and making the appropriate changes.
Problem 4.5
Unable to connect the MinIT 6000 to the host however, the AS/400 can ping the MinIT
6000, the AS/400 is at the latest PTF and CUM level and can ping other devices. Your
Network Administrator made certain that the IP addresses are correct and you have
recreated the Ethernet line and restarted all routers.
Possible Cause
Your AS/400 is not set up for enough virtual devices.
Solution
1. On the AS/400 command line, type WRKSYSVAL followed by the <enter> key.
2. Scroll down to the "System Value" of QAUTOVRT.
3. Type a 5 in the option field to display the number of virtual devices allowed.
4. Make certain that you allow for enough.
5. Printer Problems
Common MinIT 6000 printer session errors.
Problem 5.1
When you try to start the printer it says “Device already in use” , then “The connection
request has been rejected by the host”.
Possible Cause
Had a printer already configured with that name at the AS400.