Operation – Northern Industrial Tools 1961202 User Manual
Page 3
6.
Do not use the Tool if under the influence of alcohol or prescription drugs. Doing so
may cause damage to the tool, or personal injury. Do not use this or any tool if you are
tired. Use common sense at all times.
7.
Check for damaged parts. Before using this tool, carefully check for any parts that may
be missing or damaged and any other conditions that may affect the operation of this tool.
Replace or repair damaged and worn parts immediately using only qualified repair facility.
8.
Always use the proper tools. This tool was designed for a specific task. Do not alter this
tool, or use it for a purpose for which it was not intended.
9.
Be careful when connecting/disconnecting air supply. It is recommended to use quick
disconnects (not included) rather than screw-on air connections.
10.
Use compressed air only. Clean, dry, regulated compressed air at 90 PSI. Never use
oxygen, carbon dioxide, combustible gases, or any other bottled gas as a power source
for this tool.
11.
Always disconnect air supply when this tool is not being used.
NOTE: The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be understood
by the operator that common sense and caution are factors that cannot be built into this
product but must be supplied by the operator.
NOTE: READ ALL INSTRUCTIONS BEFORE USING THIS PRODUCT
OPERATION
i. Set
Up
Fig. 1
WARNING!
This impact wrench supplies powerful torque and it
designed to be operated with two hands. Failure to operate the Impact
wrench with two hands may result in serious injury.
1. You will need to prepare a 1/4" air connector (not included) to connect to the air inlet on the
tool. First, wrap the 1/4" air connector with pipe thread seal tape (not included) before
threading it into the inlet. Connect the 3/8" ID air source hose (not included) to a
quick-disconnect coupler (not included) and then to the tool.
2. Set the air pressure on your compressor to 90 PSI. Do not exceed the recommended air
Page: 3 of 7